Product show case > Test Equipment > Digital Clamp Meter
Digital Clamp Meter with 6000 count / NCV / ABP / NCF / k type temperature sensor
 
Introduction :


    Digital clamp meter integrated with AC / DC hall effect sensor, 3-3/4 Digit 6000 Count, True RMS, auto and manual measurement.

    Advance features :

      - Wide response band width.
      - Large LCD display.
      - Audible sound and visible indication during continuity check.
      - Non-contact Frequency detection ‘NCF’ 50 / 60 Hz
      - Software calibrated.

      Specifications :


        - True RMS
        - 6000 counts (3-3/4 digit)
        - Auto / Manual ‘V’ (600V AC)
        - Auto / Manual ‘V’ (AC ) with Hz / % selectable
        - Auto / manual resistor measurement (60MΩ)
        - Continuity check : <50Ω Beep
        - Diode check : 3.000 V
        - 600A / 600A (AC / DC) current
        - AC current with Hz / % selectable
        - Capacitance : 10nF - 100mF
        - Frequency 10Hz - 10MHz
        - Hz / Duty cycle 1-99%
        - ‘NCV’ Non-Contact AC Voltage Detection (Audible and Visible) > 100V : Numerical digital display AC voltage strength
        - Freeze / Hold reading
        - Auto power off : (5 mins)
        - Anti Burn Protection (ABP) on full range and up to 250V (AC / DC) (NOT at μA / mA CURRENT)
        - ‘NCF’ Non-Contact Frequency Detection
        - Relative reading (Rel)
        - Input impedance 10MΩ
        - ‘ OL ’ Over range display
        - Low battery indication (2.6V approx.)
        - Maximum Conductor diameter for measurement (mm) < Ø50
        - Maximum open jaw (mm) : Ø50
        - Measurable temperature from thermocouple -50°C ~ 1000 °C (-58°F ~1832°F) 
        - 'K' type temperature Ni-Cr and Ni-Si sensor, temperature range measurable -40°C ~ 250°C ( -40°F ~ 482°F) to be provided
        - Battery powered : 1 x 3V (CR2032)
        - Dimension (LxWxD) mm : 208x77x16
        - Weight (approx.) grams : 140 (without battery)
Item no.MS-376DFT
Further DetailsDigital Clamp Meter MS-376DFT_TE4